The "ip route-cache flow" can be used only under the main interface, while the "ip flow ingress" was an enhancement to be used under subinterfaces. The NetFlow Subinterface...

No. Cisco doesn't support NetFlow on the following devices: Cisco 2900 Cisco 3500 Cisco 3750  It is possible to configure NetFlow export, but no flows are send to the...

NetFlow VRF Export: - Allow the export of flow records within a VRF. - Valid for both SCTP* and UDP export. Router(config)# ip flow-export destination 10.1.1.2 2000 vrf testvrf...

NetFlow is most likely available in any devices on the network. Device

Please, visit the following web page  to see a brief guide to setting up the NetFlow data export (NDE) on a Cisco devices.

Output interfaces are "Null" in the following cases: The packets are blocked by an ACL. The packets are process switcheded. This could be because the feature is not supported ...

By default, the flow keys are: Source IP address, destination IP address, source port, destination port, layer 3 protocol type, ToS byte (DSCP) and input interface. On Cisco Catalyst we speak of the...

The MLS aging time (default 300 seconds) applies to all NetFlow table entries. You can configure the normal aging time in the range of 32 to 4092 seconds. Flows can age as much as 4 seconds sooner...

The commands you need for layer2-switched traffic: ip flow ingress layer2-switched vlan <vlanlist> ip flow export layer2-switched vlan <vlanlist> However, from the IOS guide: A...

You need to purchase and install a NetFlow services WS-4531 card to support NetFlow on 4500 series. You cannot enable NetFlow without this card. Update July 2010: NetFlow will be natively...

This error message is displayed on kernels with exec-shield protection - usually on Fedora/RedHat distributions. In kernels with ExecShield technology, the addresses at which these binaries are...

Several of our customers are using device and they tried to export NetFlow v9 to Caligare Flow Inspector without success. After debuging we find the problem. In the ASA NetFlow there is missing a...

This section contains Enhanced Address Recognition Logic Netflow (EARL_NETFLOW) messages. EARL_NETFLOW-0 Error Message: EARL_NETFLOW-0-NF_ECC_MAX: Netflow ECC Error Threshold Reached, Total Ecc...

The ICAM is used to handle hash collisions in the netflow table. It essentially indicates that 2 unique flows hashed to the same key in the hardware, so the netflow TCAM stores the index to the flow...

Following messages are seen while disabling/enabling QoS globally: Router#config term Enter configuration commands, one per line. End with CNTL/Z. Router(config)#no mls...

No statistics are available for flows that are switched when the NetFlow table is full. If the NetFlow table utilization exceeds the recommended utilization levels, there is an increased probability...

No, PFC3A mode does not support NetFlow bridged IP traffic. Netflow for bridged traffic requires Release 12.2(18)SXE or later. This example shows how to enable NetFlow for ingress-bridged IP...

You need to purchase and install a NetFlow services WS-4531 card to support NetFlow on 4500 series. You cannot enable NetFlow without this card. Update July 2010: NetFlow will be natively...

NetFlow VRF Export: - Allow the export of flow records within a VRF. - Valid for both SCTP* and UDP export. Router(config)# ip flow-export destination 10.1.1.2 2000 vrf testvrf...

The MLS aging time (default 300 seconds) applies to all NetFlow table entries. You can configure the normal aging time in the range of 32 to 4092 seconds. Flows can age as much as 4 seconds sooner...