Caligare NetFlow - Knowledgebase
Search:     Advanced search
Browse by category:
Glossary | Contact Us

EARL NetFlow error messages

Add comment
Views: 2848
Votes: 0
Comments: 0
This section contains Enhanced Address Recognition Logic Netflow (EARL_NETFLOW) messages.

EARL_NETFLOW-0

Error Message: EARL_NETFLOW-0-NF_ECC_MAX: Netflow ECC Error Threshold Reached, Total Ecc Errors [[dec]]

Explanation: This message indicates that the total number of NetFlow ECC errors has crossed the maximum threshold. The maximum allowable of NetFlow ECC errors is 2000. The system will perform a crash dump and will be inoperable. The output of the "show tech-support" command will also be displayed.


EARL_NETFLOW-3

Error Message: EARL_NETFLOW-3-NF_ECC_RSRV: Netflow ECC Error Occured, Reserved NF location [[hex]]

Explanation: This message indicates that the number of ECC errors per NetFlow TCAM entry has reached the maximum threshold (three or more ECC errors). The NetFlow TCAM location will now be marked as reserved and can no longer be used.


EARL_NETFLOW-4

Error Message: EARL_NETFLOW-4-ICAM_THRLD: Netflow ICAM threshold exceeded, ICAM Utilization [[dec]%]

Explanation: This message indicates that the Netflow ICAM is almost full. Aggressive aging is temporarily enabled.


Error Message: EARL_NETFLOW-4-NF_AGG_CACHE_THR: Netflow [chars] aggregation cache is almost full.

Explanation: This message indicates that the aggregation cache for Netflow is almost full. This condition might cause a high CPU load.


Error Message: EARL_NETFLOW-4-NF_FULL: Netflow Table Full, ICAM occupancy [[dec]%], TCAM occupancy [[dec]%], Entry creation failures [[dec]]

Explanation: This message indicates that the Netflow table is full, possibly because of faulty hashing behavior.


Error Message: EARL_NETFLOW-4-TCAM_THRLD: Netflow TCAM threshold exceeded, TCAM Utilization [[dec]%]

Explanation: This message indicates that the Netflow TCAM is almost full. Aggressive aging is temporarily enabled.


EARL_NETFLOW-5

Error Message: EARL_NETFLOW-5-NF_ECC_REMOVE: Netflow ECC Error Occured, Deleted NF entry [[hex]]

Explanation: This message indicates that a Netflow ECC error occurred. The affected Netflow entry has been deleted at the address specified so that a new entry will be created.

Others in this Category
document Cisco ASA and NetFlow
document What is diference between normal, fast and long mls aging?
document What is difference between "ip flow ingress" and "ip route-cache flow"?
document I would like to get NetFlow information from individual layer 2 switch ports.
document I have interface Vlan2 with record ip route-cache flow, but I have never seen traffic of this interface, although, other VLAN interfaces present in statistics.
document Is it possible to use the vrf interface as source of netflow packets?
document How can I configure netflow on Cisco?
document On which Cisco device is netflow supported?
document Is NetFlow version 9 supported on 3620? Where can I find the document to see the supported devices?
document "Unable to change flowmask" error message on Cisco 6500
document NetFlow on a Cisco 4500 series. Do I need a NetFlow services card?
document I'm seeing all in traffic passing through interface, but no out traffic.
document What means "flow mask" in the mls configuration?
document How can I enable netflow on Cisco 3550 or Cisco 3750 devices?
document What is netflow table capacity on Cisco?
» More articles



RSS