Caligare NetFlow - Knowledgebase
Search:     Advanced search
Browse by category:
Glossary | Contact Us
Knowledgebase / NetFlow / Cisco Systems / NetFlow on a Cisco 4500 series. Do I need a NetFlow services card?

NetFlow on a Cisco 4500 series. Do I need a NetFlow services card?
Print
Email to friend
Add comment
Views: 4256
Votes: 0
Comments: 0
You need to purchase and install a NetFlow services WS-4531 card to support NetFlow on 4500 series.
You cannot enable NetFlow without this card.
Others in this Category
document I'm seeing all in traffic passing through interface, but no out traffic.
document On which Cisco device is netflow supported?
document What is difference between "ip flow ingress" and "ip route-cache flow"?
document How can I configure netflow on Cisco?
document Cisco ASA and NetFlow
document I would like to get NetFlow information from individual layer 2 switch ports.
document I configured NetFlow on Cat6500, but application shows only a few MBytes, whereas it should have been several GBytes.
document When I run show ip flow top-talkers I see null destination interface. What does null interface mean?
document EARL NetFlow error messages
document What means "flow mask" in the mls configuration?
document Is it possible to use the vrf interface as source of netflow packets?
document "Unable to change flowmask" error message on Cisco 6500
document I'm seeing a WARNING: TCAM request associate message... What is it mean?
document What is netflow table capacity on Cisco?
document What means "TCAM Utilization" and "ICAM Utilization"?
» More articles


RSS
Powered by KBPublisher (Knowledge base software)