Caligare NetFlow - Knowledgebase
Search:     Advanced search
Browse by category:
Glossary | Contact Us

Is it possible to use the vrf interface as source of netflow packets?

Add comment
Views: 7678
Votes: 1
Comments: 1
NetFlow VRF Export:
- Allow the export of flow records within a VRF.
- Valid for both SCTP * and UDP export.
Router(config)# ip flow-export destination 10.1.1.2 2000 vrf testvrf <sctp|udp>
Router(config-flow-cache)# export destination 10.1.1.2 2000 vrf testvrf <sctp|udp>

where testvrf is a VRF name.
Introduced in 12.4(4)T on the low-end routers.

* SCTP is not supported by Caligare Flow Inspector at this time.
Showing: 1-1 of 1  
Comments

02 Feb, 2008   |   Peter
Nice web page. Very useful were articles about NetFlow configuration. Many thanks, Peter


Add comment

Others in this Category
document Is NetFlow version 9 supported on 3620? Where can I find the document to see the supported devices?
document I configured NetFlow on Cat6500, but application shows only a few MBytes, whereas it should have been several GBytes.
document I would like to get NetFlow information from individual layer 2 switch ports.
document What means "TCAM Utilization" and "ICAM Utilization"?
document I'm seeing all in traffic passing through interface, but no out traffic.
document On which Cisco device is netflow supported?
document How can I enable netflow on Cisco 3550 or Cisco 3750 devices?
document What is difference between "ip flow ingress" and "ip route-cache flow"?
document I'm seeing a WARNING: TCAM request associate message... What is it mean?
document EARL NetFlow error messages
document How can I configure netflow on Cisco?
document NetFlow on a Cisco 4500 series. Do I need a NetFlow services card?
document What are the optimal netflow aging values?
document What is netflow table capacity on Cisco?
document What is diference between normal, fast and long mls aging?
» More articles



RSS