Caligare NetFlow - Knowledgebase
Search:     Advanced search
Browse by category:
Glossary | Contact Us

I'm seeing all in traffic passing through interface, but no out traffic.

Add comment
Views: 2988
Votes: 0
Comments: 0
  1. Run the command:
    show ip interface brief | exclude unassigned
    to list all L3 interfaces that have assigned IP address.
  2. Check if you enabled ip route-cache cef or ip route-cache flow on all L3 interfaces.
Also read
document I configured NetFlow on Cat6500, but application shows only a few MBytes, whereas it should have been several GBytes.
document I have interface Vlan2 with record ip route-cache flow, but I have never seen traffic of this interface, although, other VLAN interfaces present in statistics.

Others in this Category
document I have interface Vlan2 with record ip route-cache flow, but I have never seen traffic of this interface, although, other VLAN interfaces present in statistics.
document I configured NetFlow on Cat6500, but application shows only a few MBytes, whereas it should have been several GBytes.
document How can I enable netflow on Cisco 3550 or Cisco 3750 devices?
document I'm seeing a WARNING: TCAM request associate message... What is it mean?
document NetFlow on a Cisco 4500 series. Do I need a NetFlow services card?
document What means "TCAM Utilization" and "ICAM Utilization"?
document EARL NetFlow error messages
document When I run show ip flow top-talkers I see null destination interface. What does null interface mean?
document I would like to get NetFlow information from individual layer 2 switch ports.
document What is diference between normal, fast and long mls aging?
document "Unable to change flowmask" error message on Cisco 6500
document Is NetFlow version 9 supported on 3620? Where can I find the document to see the supported devices?
document Cisco ASA and NetFlow
document On which Cisco device is netflow supported?
document How can I configure netflow on Cisco?
» More articles



RSS