Caligare NetFlow - Knowledgebase
Search:     Advanced search
Browse by category:
Glossary | Contact Us
Knowledgebase / Reporting / Why are some interfaces labeled as IfIndex2, IfIndex3, etc.?

Why are some interfaces labeled as IfIndex2, IfIndex3, etc.?
Print
Email to friend
Add comment
Views: 1096
Votes: 1
Comments: 0

This happens if the interfaces did not respond to the SNMP requests sent by Caligare Flow Inspector. If the interface is up, then the SNMP settings of the interface may have been set incorrectly.
Others in this Category
document Why are the graphs empty?
document How long do I have to wait before the graphs are populated?
document Why are only the top 10 values shown in the reports? Can I get a more detailed report?
document The graphs show only IN traffic for an interface, although there is both IN and OUT traffic flowing through that interface. Why's that?
document When I try to access Data, Trends, I get: Warning: No tables found for selected collector.
document The product is installed and everything seems to be running. However, all the database tables have 0 data in them.
document I did see non-zero DoS state value in the collector status.
document I'm seeing corrupted flow time in the status log.
document I saw trends results formatted into tables, but no graph is displayed.
document I saw graphs in menu "Data->Graphs", but now they aren't available.
document When I change the selected table in the trends menu available statistics are changed.
document How to configure secure LDAP authentication (LDAPS)?


RSS
Powered by KBPublisher (Knowledge base software)